RC fishing Surfer Brushless motor compatible with v1 & v2 boats!
OUT OF STOCK UNTIL END OF MAY 2026
INSTALLATION
1.) Take Out 4 Screws on the Cover of the Side of the Battery Tray that you are Changing the Motor On. You May Need
to Remove a Zip Tie From the End of the Cover by Pushing with a Screwdriver. Remove Cover, Pay Attention to the
GPS Receiver and How it Fits Back in. Do Not Disconnect Cooling Tubes by Motors.
2.) Remove the Motor by Taking Off the Propeller Nut, Propeller, and Black Nut.
3.) Plug in 3 Motor Wires, Confirm the Correct Motor Direction by Putting your Hand In Back of each Propeller, If it
Blows Outwards it is OK. If Not, Disconnect Two Random Motor Wires and Reverse the Wires. *Recalibrate After
Installing Motors. *Not Necessary to Remove the Weed Guard, Note the Screws Are Not the Same, Coarse and Fine
Thread. You Should Use Silicone in the Screw Holes When you Re-install them.
