MUST REPLACE BOTH DO NOT USE ORIGINAL MOTOR AND HI POWER MOTOR TOGETHER
1880 KV 30% More Power VS the Old 1300 KV Motors
INSTALLATION
1.) Take Out 4 Screws on the Cover of the Side of the Battery Tray that you are Changing the Motor On. You May Need
to Remove a Zip Tie From the End of the Cover by Pushing with a Screwdriver. Remove Cover, Pay Attention to the
GPS Receiver and How it Fits Back in. Do Not Disconnect Cooling Tubes by Motors.
2.) Remove the Motor by Taking Off the Propeller Nut, Propeller, and Black Nut.
3.) Plug in 3 Motor Wires, Confirm the Correct Motor Direction by Putting your Hand In Back of each Propeller, If it
Blows Outwards it is OK. If Not, Disconnect Two Random Motor Wires and Reverse the Wires. *Recalibrate After
Installing Motors. *Not Necessary to Remove the Weed Guard, Note the Screws Are Not the Same, Coarse and Fine
Thread. You Should Use Silicone in the Screw Holes When you Re-install them.
4. ) If you Install the Hi-Power 1800 Motors They May Trigger the Low Battery Alarm, Even When the Battery is Fully Charged. You Can Install a Second Battery Connected to the Receiver. The Battery is Available on Ebay and Amazon 11.1V 2200mAh 3S Lipo Battery JST JR Futaba Plug . You Will Need to Remove the Side of the Battery Tray that has the Battery Cable. Locate the Plug Labeled B/V, Unplug it and Plug it into the New Battery. This will Override the Low Battery Alarm.
